Here you can activate device in specific mode or switch device from Light or Hardware test mode to the Premium mode.

Device ID

Identificator of ODrive controller to which license is bound. You will need to provide ID of your ODrive when purchasing a license.

Activation

To activate a device select device type in dropdown list, input serial key (in case you have one), and press Activate button.

Light mode (Wheel only!)

• By default wheel firmware is activated in light mode, it has basic wheel functionality needed to build a wheel. For extended functionality you will need to have proper license key.

Hardware test mode (Flight controls only!)

• Without a valid KEY device you can activate any flight controls in Hardware test mode. In this mode all settings are available so you can perform initial setup and tests without a need to purchase a license.
• The only restriction of the mode is that device will act as simple spring joystick and will not react on DirectX FFB and FFBeast commander commands.

License key

• License key is connected to serial number of STM32 controller used in ODrives.
• In case you will burn a chip license will be lost. So treat your ODrive carefully: do not make short circuits, reverse power polarity and other “wrong things” in terms of electronics. Secure and isolate all wires and your ODrive will work forever!